Troubleshooting the 1600 Focus™ Vapor Steamer.

ProblemPossible CauseSolution
Does not produce heat.High limit control is tripped.Reset by pushing in reset button on sensor (see below). Turn the thermocoupler knob counter-clockwise by 15-25 degrees. Run to make sure it is functioning properly. If control trips again repeat process of reseting and turning thermocoupler counter-clockwise.
Does not spray.Clogged nozzle.Clean nozzle.

** Use only distilled water to avoid mineral build-up in the system. **

Locating Sensor Reset Button

To reset a tripped high limit control, press the small white and yellow button on the sensor on top of the kettle indicated below.